www.raisecom.com
Chapter 5 Basic Connection and Typical Application
5.1 Basic connection
5.1.1 Connect the optical interface
Insert the well-prepared fiber patch cord into the optical interface on the front panel of the device.
For device adopting optical transceivers M, S1, S2 or S3, the optical interface connection pattern is
shown in the figure below. On the device panel, "TX" indicates output optical signal, while "RX"
indicates input optical signal.
For device adopting optical transceiver SS13, SS15, SS23 or SS25, the optical interface connection
manner is shown in the figure below. In this circumstance, the optical interface will receive as well
as transmit signals. "TX" and "RX" on the device panel have no meaning. For details, please refer to
the ordering information in section 1.3.
Optical interface connecting - 1
Optical interface connecting – 2
User Manual
19