Table of Contents
Advertisement
www.raisecom.com
5.1 Basic Connection
5.1.1 Connect the optical interface
Insert the well-prepared fiber patch cord into the optical interface on the front panel of the device.
For device adopting optical transceivers M, S1, S2 or S3, the optical interface connection pattern is
shown in Figure 5-1. On the device panel, "TX" indicates output optical signal, while "RX" indicates
input optical signal.
For device adopting optical transceiver SS13, SS15, SS23 or SS25, the optical interface connection
manner is shown in Figure 5-2. In this circumstance, the optical interface will receive as well as
transmit signals. "TX" and "RX" on the device panel have no meaning. For details, please refer to
the ordering information in section 1.3.
Chapter 5 Basic Connection and Typical Application
Figure 5-1 The connection of the optical interface - 1
Figure 5-2 The connection of the optical interface – 2
User Manual
15
Advertisement
Table of Contents
