Table of Contents
Advertisement
www.raisecom.com
Note: the explanation of each command is available in A.10 Line Board Setting menu.
c. 2E1 optical card with CPU, the menu will be:
Note: the explanation of each command is available in A.11 2E1 Setting menu.
d. The contents of unknown up-link card have not been registered in system, so relevant
configuration information can not be confirmed. In this case, holistic setting solution is available to
users, that is users can input binary digit for relevant bytes one by one and the below information
will display:
Every byte can be set with different contents according to card type.
If user presses ENTER key direct instead of inputting number, the old setting is effective and system
enter mode of the next byte. Once input any content, the command will be effective when pressing
ENTER key after inputting all contents.
Pressing ENTER key at the end of byte inputting means confirm the command, and press E key
means finish the input and save the former input setting.
Pressing Esc key at any time means cancel the setting.
In case of no content is input, use ↓, ↑keys to shift setting contents and view the setting value. There
are 7 bytes of setting contents:
A.9.4 E1 set
In system setting menu press number key 4 to configure E1 interface and the menu will be:
Note: The explanation of each command is available in A.12 E1 set
6.Transmit Band Width Set
7.Receive Band Width Set
8.Reset Ether Net
Optical Board Set Command:1-8, Menu Display: M, Return: Q
1.Alarm Mask Set
2.Loopback Set
3.ALS Set
Optical Board (2E1) Set Command:1-3, Menu Display: M, Return: Q
Line-board mode 1 (set value: 0 0 0 0 0 0 0 0 ):
Line-board mode 1
Line-board mode 2
...
Line-board mode 7
1.Use Set
2.Mode Set
3.Mask Set
4.CRC Set
E1 Set Command:1-4, Menu Display: M, Return: Q
Command:
Command:
Command:
User Manual
66
Advertisement
Table of Contents
