Table of Contents
Advertisement
www.raisecom.com
A.4.1 Device ID and Baud rate
In device set query menu press number key 1, and there will be device ID and baud rate information:
Device ID is range in 0~255, 0 indicates have not set device ID. Baud rate contains four kinds: 1
(300bps), 2 (2400bps), 3 (4800bps) and 4 (9600bps). 0 indicates the baud rate has not been set.
A.4.2 Line-Board information (RAM):
In device set query menu press number key 2, and then there will be device Line-Board information:
There will be Line-Board name for each Line-Board card. If a Line-Board card cannot be configured
there will not be configuration information and status information. At present only optical
Line-Board card has configuration information as follows:
1.Device ID and Baud rate
2.Line-Board info(RAM)
3.Line-Board info(EEPROM)
4.E1 using and mode info
5.Clock,CRC and Net info, version setting
6.E1 Alarm Mask info
7.Sub-card info(RAM)
8.Sub-card info(EEPROM)
Device Query Command:1-8, Menu Display: M, Return: Q
Device ID:1
Baud Rate:2(2400bps)
Device Query Command:1-8, Menu Display: M, Return: Q
Real information:
Line-Board Type:2E1 Board (Line-Board card name)
Device Query Command:1-7, Menu Display: M, Return: Q
Real information:
Line-Board Type:Optical Board +100M Ethernet
Software Version:REV 1.1
Optical Module Type: AS1
Alarm Mask: 1=Mask Optical LOS| Frame LOF | E-3 ERROR | E-6 ERROR
Local:
Remote:
Loopback State: the 1
Ether Net Set:
PCB Version:REV A.1
ALS: Enable
0
0
0
0
st
nd
and 2
E1 loop at local
Command:
Command:
Command:
0
0
0
0
User Manual
51
Advertisement
Table of Contents
