Table of Contents
Advertisement
www.raisecom.com
configuration items; Press ENTER to confirm configuration, press E key to finish configuration, and
ESC to cancel configuration.
The configuration items are: Auto Mode: Enable/Disable
Port Speed: 100M/10M
Port Mode: Full Duplex/Half Duplex
AUTO-MDI/MDIX: Enable/Disable
A.10.6 Transmit Band Width Set
In optical line-board setting menu press number key 6 to configure Ethernet interface Tx Band
Width:
The first row is present configuration value and the second row is for your configuration.
If you do not set bandwidth value in the second row and just press ENTER, the old configuration
will be reserved. If you set the bandwidth value (the entering can only be number and within the
range of 0-4095) and press ENTER, the new configuration will be effective. BackSpace key is
available to modify the input value.
A.10.7 Receive Band Width Set
In optical line-board setting menu press number key 7 configure Ethernet interface Rx Bandwidth:
The first row is present configuration value and the second row is for your configuration.
If you do not set bandwidth value in the second row and just press ENTER, the old configuration
will be reserved. If you set the bandwidth value (the entering can only be number and within the
range of 0-4095) and press ENTER, the new configuration will be effective. BackSpace key is
available to modify the input value.
A.10.8 Reset Ether Net
In optical line-board setting menu press number key 8 to reset the Ethernet interface:
Press Y key to confirm the operation and press N key to return, others keys are invalid.
A.11 2E1 Setting menu
This section is explanation of 2E1 setting, the content displays after enter line-card setting from
Transmit Band Width: 4095 x 32Kbps
Set (0-4095):
Receive Band Width:4095 x 32Kbps
Set(0-4095):
To run this command will reset Ethernet port.
Run this command (Y/N):
User Manual
74
Advertisement
Table of Contents
