Table of Contents
Advertisement
www.raisecom.com
Note: Band Width Buffer is used to adjust buffer to reduce latency.
Sub-card type 9 RS232 serial interface user card:
Note: the bandwidth configuration can be only 64kbps or 128kbps; there are 8 channels at 64kbps
and 4 channels at 128kbps.
Sub-card type 10 RS422 serial interface user card:
Note: the bandwidth configuration can be only 64kbps or 128kbps; there are 8 channels at 64kbps
and 4 channels at 128kbps.
Sub-card type 11 magneto telephone card:
Sub-card type 12 FXS polarity reversible user card:
Sub-card type 13:
Note: the bandwidth configuration can be only 64kbps or 128kbps; there are 8 channels at 64kbps
and 4 channels at 128kbps.
Sub-card type 14:
Defeat Link Default Set: Full Duplex
Link State:Link UP
Work State:Full Duplex
Type: 9 RS232 User Board
PCB version: REV A.3
Signal: None
Band Width:64Kbps
Type:10 RS422 Board
PCB version: REV A.3
Signal:Exist
Band Width:64Kbps
Type:11 Magneto Board
PCB version: REV A.3
Signal: Exist
Signal In: Original
Signal Bit(D7:D0):A A A A B B B B
Type:11 FXS polarity reversible Board
PCB version: REV A.3
Signal: Exist
Signal In: Original
Signal Bit(D7:D0):A A A A B B B B
Type: 12 R485 interface Board
PCB version: REV A.3
Signal: None
Bandwidth: 64Kbps
Type: 14 FXS polarity reversible Board
PCB version: REV A.3
Timeslot Number: 8
Set Mode: Hardware
CPLD version: REV 1.0
Timeslot Number: 8
Set Mode:Hardware
CPLD version: REV 1.0
Timeslot Number: 8
Set Mode:Hardware
CPLD version: REV 1.0
Signal Out: Reversal Original
Timeslot Number: 8
CPLD version: REV 1.0
Signal Out: Reversal Original
Timeslot Number: 8
CPLD version: REV 1.0
Timeslot Number: 4
CPLD version: REV 1.0
Set Mode:Hardware
Set Mode:Hardware
Set Mode: Hardware
User Manual
58
Advertisement
Table of Contents
