Set The Dip Address Of The Slave Cv-Tac400; Starting The Sft5202 Windows Client Software - CAMDEN Invision TAC Series Installation Manual

Telephone access system
Table of Contents

Advertisement

Address
15
16

10. Set the DIP Address of the Slave CV-TAC400

From the front panel of the Slave CV-TAC400, select 3 Service Menu from the Main Menu.
Select 2 Change ELP Address.
Service Menu
1. Change password
2. Change ELP Address
3. ELP Setup Menu
4. ELP Status Menu
To change the CV-TAC400 DIP Address, enter the new address using the number keys. Select an
address from the table below. To save the address you have just entered press the # key. To exit
without changing the password enter the * key.
There must be one and only one Master CV-TAC400. Each system may only have up to 3 slave CV-
TAC400's. The addresses must be unique within each system.
Address
1
14
15
16

11. Starting the SFT5202 Windows Client Software

The following instructions apply only if the default file locations were used in the software installation. If
any changes were made, that location should be used.
To start the SFT5202 Windows Client Software open (double click) the SFT5202 icon on the desktop
If there is no SFT5202 icon on the desktop, the following steps may be performed:
a. select the Start Menu from the windows desktop
b. select Programs from the start menu
c. select the "remoteAdmin" folder
d. select SFTD5202D from the list. The main SFT5202 Windows Client Software window will be
displayed
File: CV-TAC400_IN_MAN__NF_REV6.doc
Revised: September 2, 2014
Part No: 40-82B113
CV-TAC400 Operation
CV-TAC400 Slave 2
CV-TAC400 Slave 3
CV-TAC400 Operation
CV-TAC400 Master
CV-TAC400 Slave 1
CV-TAC400 Slave 2
CV-TAC400 Slave 3
CV-TAC400 Installation Guide | 98
5. Dispatch / Request Data
6. Restore ELP Default
7. Exit

Advertisement

Table of Contents
loading

Related Products for CAMDEN Invision TAC Series

This manual is also suitable for:

Invision cv-tac400

Table of Contents