Table of Contents
Advertisement
In the "Com Port" drop down box, select the COM Port the Modem is connected to.
f.
g. In the "Data Bits" box select 8.
h. In the "Flow Control" box select "none".
In the "Parity" box select "None".
i.
In the "Stop Bits" box select "1".
j.
k. In the "Echo" box select ""Off".
When you are done Save the settings by selecting the "Save Settings" button
l.
Initializing the Modem
NOTE: The modem will remain initialized until the SFTD5202 software is shutdown. This initialization
procedure must be performed each time the SFTD5202 software is restarted.
To initialize the modem follow the steps below:
a. Ensure the "Communication Setting" form is displayed.
b. Select the "Save" button.
File: CV-TAC400_IN_MAN__NF_REV6.doc
Revised: September 2, 2014
Part No: 40-82B113
CV-TAC400 Installation Guide | 22
Advertisement
Table of Contents
