CAMDEN Invision TAC Series Installation Manual page 5

File: CV-TAC400_IN_MAN__NF_REV6.doc
Revised: September 2, 2014
Part No: 40-82B113
Changing/Adding Suite Information ___________________________ 87
18.PIN Entry Information _________________________________ 88
19.Backup the Data _____________________________________ 89
20.Uploading Saved Information into the CV-TAC400 __________ 90
Basic Master with Slave Unit and Access Control ________________ 92
Hardware Connections ______________________________________ 92
1.Connect the Telephone Line ____________________________ 92
2.Connect the Modem Module (Optional) ____________________ 92
3.Connect the Computer _________________________________ 93
4.Connect the Reader Installed in the CV-TAC400 ____________ 94
5.Connect the Slave ____________________________________ 94
6.Connect the Door Lock _________________________________ 95
7.Connect the Power ____________________________________ 95
8.Set the Time and Date _________________________________ 96
9.Set the DIP Address of the Master CV-TAC400 to 1 __________ 97
10.Set the DIP Address of the Slave CV-TAC400 _____________ 98
11.Starting the SFT5202 Windows Client Software ____________ 98
12.Establishing a Connection with the CV-TAC400 ____________ 99
Remote Connection Using a Modem __________________________ 99
Configuring the SFTD5202 Software for the Modem ____________ 99
Setting the Remote Modem _________________________________ 101
Starting a Connection ______________________________________ 102
A.RS485 to USB Converter ______________________________ 104
13.Open a Session with the CV-TAC400 (Working Online with an
RS485 Converter)) ____________________________________ 106
14.Open a Session with the CV-TAC400 (Working Online with a
Modem Connection) ___________________________________ 106
15.Changing the Greeting Message _______________________ 107
16.Load the Factory Default _____________________________ 108
17.Setup the CV-TAC400's Configuration to Allow Slaves ______ 110
18.Set the Facility Code ________________________________ 111
19.Setup the Access Control Information ___________________ 112
20.Entering Suite Information ____________________________ 117
Changing/Adding Suite Information __________________________ 117
15, Configuring Users for Access Control ___________________ 118
21.PIN Entry Information ________________________________ 119
22.Backup the Data ____________________________________ 120
23.Uploading Saved Information into the CV-TAC400 _________ 121
CV-TAC400 Installation Guide | 5