Table of Contents
Advertisement
If you enter the wrong password five times in a row, you will be locked out of the unit for 2Hrs. Even
the help code will not be available.
If the wrong password is entered the display will show: "Password Incorrect". You may then repeat the
process.
From the main menu select 4. Date & Time
The Date and Time menu allows changing the CV-TAC400's date and time. When the Date and Time
menu is selected a display similar to the example figure below will be displayed.
To change the date or time you position the cursor under the item you want to change and then use the
1 and 3 keys to increment or decrement that item. The # key moves the cursor right and at the end of
the line moves down to the next line. The * key moves the cursor left and at the left end of the line the
cursor moves up to the next line.
When you have finished changing the date and time the 0 key exits to the main menu.
The following table summarizes how the keys affect the display:
Key
#
*
1
3
0
7. Set the DIP Address of the CV-TAC400 to 1
From the front panel of the Master CV-TAC400, select 3 Service Menu from the Main Menu.
Select '2', Change ELP Address.
Service Menu
1. Change password
2. Change ELP Address
3. ELP Setup Menu
4. ELP Status Menu
To change the CV-TAC400 DIP Address, enter the new address using the number keys. Select an
File: CV-TAC400_IN_MAN__NF_REV6.doc
Revised: September 2, 2014
Part No: 40-82B113
ELP Time and Date:
Action
Moves cursor right and down
Moves cursor left and up
Increments the value above the cursor
Decrements the value above the cursor
Exits the date and time menu
2009–Oct-19
Monday
16:14:16
5. Dispatch / Request Data
6. Restore ELP Default
7. Exit
CV-TAC400 Installation Guide | 19
Advertisement
Table of Contents
