Table of Contents
Advertisement
To communicate with a remote system via modem you must first start the connection. As the system does
not know which system will be connected you do not use start session.
Starting the Connection
a. To start a connection to a remote system follow the steps below:
b. Start the SFT5202 Windows Client Software.
c. Select the "Setup" menu. A list of submenus will be displayed
d. Select the "Dial Up" submenu. The "Dial Up" form will be displayed.
e. Select the remote site from the list of remote sites in the "Building" drop down list. If the building is
not in the list you may enter the information in the form.
Select the "Dial up" button to start the connection or Close to exit with starting the connection.
f.
File: CV-TAC400_IN_MAN__NF_REV6.doc
Revised: September 2, 2014
Part No: 40-82B113
CV-TAC400 Installation Guide | 48
Advertisement
Table of Contents
