Table of Contents
Advertisement
From the main menu select 4:. Date & Time
The Date and Time menu allows changing the CV-TAC400's date and time. When the Date and Time
menu is selected, a display similar to the example figure below will be displayed.
To change the date or time, you position the cursor under the item you want to change and then use
the 1 and 3 keys to increment or decrement that item. The # key moves the cursor right, and at the end
of the line moves down to the next line. The * key moves the cursor left, and at the left end of the line
the cursor moves up to the next line.
When you have finished changing the date and time, the 0 key exits to the main menu.
The following table summarizes how the keys affect the display:
Key
#
*
1
3
0
8. Set the DIP Address of the Master CV-TAC400 to 1
From the front panel of the Master CV-TAC400, select 3 Service Menu from the Main Menu.
Select 2 Change ELP Address.
Service Menu
1. Change password
2. Change ELP Address
3. ELP Setup Menu
4. ELP Status Menu
To change the CV-TAC400 DIP Address, enter the new address using the number keys. Select an
address from the table below. To save the address you have just entered press the # key. To exit
without changing the password enter the * key.
There must be one and only one Master CV-TAC400. Each system may only have up to 3 slave CV-
TAC400's. The addresses must be unique within each system.
File: CV-TAC400_IN_MAN__NF_REV6.doc
Revised: September 2, 2014
Part No: 40-82B113
ELP Time and Date:
Action
Moves cursor right and down
Moves cursor left and up
Increments the value above the cursor
Decrements the value above the cursor
Exits the date and time menu
2009–Oct-19
Monday
16:14:16
5. Dispatch / Request Data
6. Restore ELP Default
7. Exit
CV-TAC400 Installation Guide | 72
Advertisement
Table of Contents
