Table of Contents
Advertisement
4. Connect the Reader Installed in the CV-TAC400
Connect the reader installed in the CV-TAC400 to the connections in the CV-TAC400. The minimum
connections are power, ground, D0 and D1.
5. Connect the Slave
Connect the Slaves RS485 bus (A1B1) to the Masters RS485 bus (A1B1).
File: CV-TAC400_IN_MAN__NF_REV6.doc
Revised: September 2, 2014
Part No: 40-82B113
Figure 23 - Access Control Reader Connections
Figure 24 - Slave to Master Connections
CV-TAC400 Installation Guide | 94
Advertisement
Table of Contents
