Using The Lateral Connector; Selection Table For Countersunk Head Screws; Required Tools And Materials - Otto Bock Harmony E2 4R152 Instructions For Use Manual

>

Required tools and materials:

Torque wrench, M12x1.5 locking screw, TPU insert (thin) for 5R2 or TPU insert (thick) for
TEC plate, PE solid rod (PE sinter filter)
1) Screw the locking screw into the lateral connector of the adapter plate and tighten (mounting
torque: 3 Nm) (see fig. 13).
2) Press the PE solid rod into the TPU insert to the stop (see fig. 14).
3) Slide the TPU insert with the PE solid rod into the connector on the proximal side of the
adapter plate (see fig. 15).

Using the lateral connector

> Required tools and materials:
Torque wrench, 2 mm Allen wrench, M12x1.5 locking screw, PE solid rod (PE sinter filter), O-
ring for hose connector, hose connector
1) Screw the locking screw into the proximal connector of the adapter plate and tighten (mount­
ing torque: 3 Nm) (see fig. 16).
2) Press the PE solid rod into the lateral connector of the adapter plate up to the stop (see
fig. 16).
3) Insert the O-ring into the groove of the hose connector.
4) Use the Allen wrench to screw the hose connector into the lateral connector and tighten
(installation torque: 1 Nm) (see fig. 16).
5.2.2 Installing the Adapter Plate
CAUTION
Improper assembly of the screw connections
Risk of injury due to breakage or loosening of the screw connections
Clean the threads before every installation.
►
Apply the specified torque values.
►
Follow the instructions regarding the length of the screws and about how to secure the
►
screws.
INFORMATION
Note the position of the Harmony E2 vacuum pump in the prosthesis. The vacuum pump must
not bump against the prosthesis or project beyond the flexed prosthetic knee joint. Use the
4R153=1 adapter plate with offset if you require greater lateral clearance (see fig. 23, see
fig. 24).
Chosen socket adapter
4R22, 4R23, 4R54, 4R55, 4R73=A, 4R73=D, 4R74, 4R95
4R37, 4R51, 4R77
> Required tools and materials:
710D4 Torque Wrench, 636K13 Loctite® 241
1) Position the adapter plate on the lamination disc with the desired alignment (see fig. 17).
2) Set the chosen socket adapter onto the adapter plate (see fig. 18).
3) INFORMATION: Secure the screws with Loctite®.
Insert the screws through the socket adapter and the adapter plate into the lamination disc
and, in diagonal sequence, tighten them using a torque wrench (mounting torque: 12 Nm)
(see fig. 19).

Selection table for countersunk head screws

Screws to be used
501S128=M6X35
501S128=M6X38
21