Configuring A Service Profile - Nortel 2350 Installation And Basic Configuration Manual

108 Configuring a 2370, 2360, or 2380 Switch for Basic Service
To display configuration information for all Distributed APs configured in the Mobility Domain, use the
following command:
show dap global [dap-num | serial-id serial-ID]
The following command lists configuration information for the Distributed APs in
2370# show dap global
Total number of entries: 12
DAP Serial Id
--- ----------- --------------- ----
1 0322199999 10.10.10.4
- 0322199999 10.10.40.4
- 0322199999 10.10.50.4
2 0322199998 10.10.10.4
- 0322199998 10.10.40.4
- 0322199998 10.10.50.4
- 0322199997 10.10.40.4
- 0322199997 10.10.50.4
- 0322199996 10.10.40.4
- 0322199996 10.10.50.4
- 0322199995 10.10.40.4
- 0322199995 10.10.50.4
This example assumes that each WSS in
each AP that is not directly connected to the WSS. The APs that are directly connected to 10.10.10.4 (WSS1)
are not configured as Distributed APs on WSS1, but they are configured as Distributed APs on the other WSS.
On WSS1, the directly connected APs are configured using AP access ports, with the set port type ap
command.
A DAP number is listed only for Distributed APs that are configured on the WSS on which you type the
command. For Distributed APs configured on other WSSs, a hyphen ( - ) is displayed in the DAP field.
The bias determines the WSS a Distributed AP prefers for booting, configuration, and data transfer. (For infor-
mation about bias and how to configure it, see the Nortel WLAN 2300 System Software Configuration Guide.)

Configuring a Service Profile

A service profile controls advertisement and encryption for an SSID. You can specify the following:
• Whether SSIDs that use the service profile are beaconed
• Whether the SSIDs are encrypted or clear (unencrypted)
• For encrypted SSIDs, the encryption settings to use
• The fallthru authentication method for users that are not authenticated with 802.1X or MAC
authentication. The fallthru method can be Web, last-resort, or none. (See
Authenticating Users" on page
Table 9 on page 109 lists the parameters controlled by a service profile and their default values.
320656-A
WSS IP Address Bias
HIGH
HIGH
HIGH
HIGH
HIGH
HIGH
HIGH
HIGH
HIGH
HIGH
HIGH
HIGH
Figure 21 is configured with a Distributed AP connection (DAP) for
101.)
Figure 21 on page 82:
"Configuring for