Operating Parts; Pto Shaft; Hydraulic Assembly - SaMASZ SAMBA 160 Operator's Manual

Tab. 3. Location of center of gravity
Dimension
[mm / ft. in]
SAMBA 160
A 505 / 1' 7.8"
B 60 / 2.4"
C 670 / 2' 2.4"

4.5. Operating parts

Prior to operating the mower check condition of both the knife and the knife holder.
❑
Worn or damaged knives or knife holders should be replaced immediately with new ones.
❑
WARNING!
During replacement of working parts, it should be used personal protective
gloves.

4.6. PTO shaft

Prior to operating learn provisions found in bar manufacturer's manual placed on the shaft.
❑
Use only the mower's manufacturer recommended PTO shafts featuring guards in good technical
❑
condition.
In order to operate safely use only fully technically fit, undamaged PTO shafts. Damaged PTO
❑
shaft shall be repaired or replaced with new one.
Prior to approaching any operation, make sure that PTO rears have proper rotational direction.
❑

4.7. Hydraulic assembly

Caution! Hydraulic assembly is under pressure! Hydraulic oil under pressure may permeate
❑
through skin and cause serious injury, therefore skin and eyes should be protected in particular. In
case of injuries caused by liquid under pressure, call doctor immediately.
Hydraulic hoses can be connected to tractor's hydraulics, provided that both the tractor's and the
❑
mower's hydraulic assemblies are not under pressure. To remove the pressure from the hoses just
simply restart the tractor's hydraulic valves several times, once the tractor is off.
When dismounting the machine from the tractor, set the equipment aside, deflate the pressure
❑
from hydraulics and turn tractor's engine off.
When inspecting hydraulic assembly's malfunction and looking for oil leaks, it is forbidden to
❑
touch any potential leaks until the entire assembly is under pressure.
Note! It is recommended that the using hydraulic oil should not exceed 10 oil purity class
❑
in accordance with NAS 1638.
When using hydraulic hoses:
Avoid stretching the hoses during operating.
❑
Do not allow hydraulic hoses to get deflected.
❑
Do not expose hydraulic hoses to contact with any sharp edges.
❑
If damaged or worn, replace the hoses with new ones.
❑
Useful life for hydraulic hoses is 5 years from their production date.
❑
Operator's manual
Instrukcja obsługi
Mower type
SAMBA 200 SAMBA 240
510 / 1' 8" 515 / 1' 8.3"
80 / 3.15" 200 / 0.8"
710 / 2' 4" 710 / 2' 4"
- 11 -
Lightweight, rear disc mowers
SAMBA
SAMBA 280 SAMBA 320
510 / 1' 8" 510 / 1' 8"
360 / 1' 2.2" 365 / 1' 2.4"
770 / 2' 6.3" 700 / 2' 3.6"