SaMASZ SAMBA 160 Operator's Manual page 21

a)
In order to prepare the mower lifted on the tractor for transport - on a - road:
lift up mower's front guard and secure it with pin,
❑
lift the mower with tractor hydraulic lift onto the tractor links until the lower lift pins of the mower
❑
3-point linkage frame are raised about 50 cm above the ground (Fig. 12),
remove safety pin (1) and place it in bushing (2) (Fig. 8a),
❑
lift the cutter bar vertically with hydraulic cylinder and lock the locking pawl (Z) (Fig. 8b),
❑
protect the cutter bar from falling by disconnecting shut-off valve (Z) (Fig. 11b) found on mower's
❑
cylinder,
dismount PTO shaft from tractor,
❑
lift up support leg and secure it with cotter.
❑
WARNING!
When transporting the machine, shut-off valve lever must be in (Z) position –
closed (Fig. 11b). Thanks to this, the mower is protected from accidental
dismantling on unexpected motion of both the tractor and the mower – in worst
case, it might cause cracks to hydraulic hose and lead to an accident.
a)
Fig. 11. Cylinder valve in position: a) opened O (work), b) closed Z (transport)
Operator's manual
Instrukcja obsługi
Fig. 10. Manner of setting front guard for transport
O
Lightweight, rear disc mowers
O
O
S
b)
Z
b)
- 19 -
SAMBA
S