Operating Parts; Telescopic Articulated Shaft; Hydraulic Assembly - SaMASZ TANGO 730 Operator's Manual

162'' / 4115 mm

4.4. Operating parts

Prior to operating the rake check condition of both the rotor and raking tines.

Worn or damaged tines should be replaced immediately with new ones.

WARNING!
When replacing working parts, always use protective gloves.

4.5. Telescopic articulated shaft

Prior to operating learn provisions found in the shaft manufacturer's manual placed on the shaft.

Use the shafts recommended by the mower's manufacturer only.

In order to operate safely use only fully technically fit, undamaged telescopic articulated shafts.

Damaged telescopic articulated shaft shall be repaired or replaced with new one.
Before any operation make sure whether PTO rpm have proper rotational direction.


4.6. Hydraulic assembly

CAUTION! Hydraulic assembly is under pressure! Hydraulic oil under pressure may permeate

through skin and cause serious injury, therefore skin and eyes should be protected in particular.
In case of injuries caused by liquid under pressure, call a doctor immediately.
Hydraulic hoses can be connected to tractor's hydraulics, provided that both the tractor's and the

rake's hydraulic assemblies are not under pressure. To remove the pressure from the hoses just
simply restart the tractor's hydraulic valves several times, once the tractor is off.
When dismounting the machine from the tractor, set the equipment aside, deflate the pressure

from hydraulics and turn tractor's engine off.
When inspecting hydraulic assembly's malfunction and looking for oil leaks, it is forbidden to

touch any potential leaks until the entire assembly is under pressure.
CAUTION! It is recommended that the hydraulic oil used should not exceed 10 oil purity

class in accordance with NAS 1638.
Instruction manual
Fig. 5. Location of centre of gravity
- 8 -
Two rotor rake
TANGO