SaMASZ SAMBA 160 Operator's Manual page 9

DO NOT exceed value of 600 rpm (for: SAMBA 160, 200, 240, 280) or 1050 rpm (for: SAMBA
❑
320 for spline shaft.
No unauthorized personnel is allowed to remain within the danger area of at least 50 m. Keep
❑
particular caution when operating near roads and in stony areas.
Any maintenance and adjustment work is allowed only with the drive disconnected and the cutting
❑
disks in complete standstill and wearing protective gloves and appropriate tools.
Condition of knives should be examined each time before commencing any operation. Damaged or
❑
worn knife holders must be replaced.
WARNING!
Any service and repair operations must be conducted with the tractor drive
disconnected and ignition key out, cutter bar lifted onto the ground while all
rotating parts in the complete standstill. Caution! Cutting knives keep rotating for
several minutes after the engine is stopped.
WARNING!
Keep the children away from the mower both in operation and standstill.
When the mower is lifted for repair on the 3-point linkage, it should be protected against accidental
❑
falling by a mechanical support or by chain.
Bolts and other fasteners should be inspected on regular basis. Operating with damaged or worn
❑
fasteners is not admissible.
Locking pawl line should be mounted with relevant tolerance in the tractor cabin.
❑
When operating the mower, please comply with the Resolution of the Minister of Agriculture and
❑
Food Economy of 12-01-1998 on work safety when operating tractors, machines, technical
instruments and devices used in farming Dz. U. nr 12/98 poz. 51.
When operating the mower, the tractor should always be equipped with operator's cabin.
❑
Mower should not be operated when the cooperating tractor is not well balanced.
❑
The mower shall never be started when it is lifted up.
❑
The mower shall never be started, with persons or animals near the machine.
❑
Prior to starting the mower, make sure there are no animals underneath the tarpaulin cover.
❑
The safety guard shall never be lifted until rotating assemblies are in complete standstill. Tractor's
❑
engine must be turned off. Caution! Cutting knives keep rotating for several minutes after the
engine is stopped.
Always comply with safety decals describing hazards, and warning signs placed on the machine.
❑
Before starting the tractor make sure that each drive is disconnected while the hydraulics control
❑
levers are in neutral position.
Do not let the tractor's engine operate without any supervision. Before leaving the tractor, turn the
❑
engine off and take the ignition key out.
It is forbidden to drive the mower backwards when operating.
❑
Never get onto the mower.
❑
Operator's manual
Instrukcja obsługi
- 7 -
Lightweight, rear disc mowers
SAMBA