SaMASZ SAMBA 160 Operator's Manual page 32

Moreover:
perform any necessary paintwork repair,
❑
examine oil level in axis gears and cutter bar (item 7). If leaks are found remove them immediately
❑
and refill the oil. If water is found in the oil, it must be replaced, otherwise the gears, bearings and
shafts could be exposed to corrosion: what in result could lead to further failures,
perform periodic checkups of the mower and protect all operating parts with grease in order to
❑
prevent their baking and creating any sources of corrosion, which significantly influences mower's
proper operation,
control hydraulic hoses on regular basis. If damaged or worn, replace the hoses with new ones.
❑
Expiry period for hydraulic hose should be no longer than 5 years from the date of manufactured
marked on a hose.
Tab. 4. Torque values for bolts
In the absence of specific torque values, the following chart can be used as a guide to the
maximum safe torque for a particular size and grade of fastener. There is no torque difference for fine
or coarse threads. Torque values are based on clean, dry threads. Reduce value by 10% if threads are
oiled before assembly.
After storage period, before the machine is used:
check the mower's technical condition, and the transmission in particular,
❑
supplement the paint where missing,
❑
make sure that all nuts and screws are tightened properly,
❑
make sure that all guards are in place,
❑
protect all moving parts with grease in order to prevent their baking and creating any sources of
❑
corrosion, which significantly influences mower's proper operation,
check oil level in axis gears and cutter bar. If leaks are found remove them immediately and refill
❑
the oil. If water in oil is found, immediately change the oil as it could cause corrosion of internal
mechanisms such as gear wheels, bearings, or shafts, and cause breakdowns.
Operator's manual
Instrukcja obsługi
- 30 -
Lightweight, rear disc mowers
SAMBA