Data Of The Version 750-464/020-000 (Ntc, Configurable); Ntc 10 Kohm; Table 46: Process Image For 750-464/020-000, Ntc 10 Kohm Setting - WAGO -I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-464 2/4 AI RTD configurable
4.5 Data of the Version 750-464/020-000 (NTC,
configurable)
4.5.1

NTC 10 kOhm

With the setting "NTC 10 kOhm", the I/O module converts the resistance
measured values of NTC 10kOhm resistance sensors and outputs them as
temperature values.
The temperature values are displayed at a resolution of 1 digit per 0.1 °C in one
word (16-bit). Temperature values below 0 °C are represented in two's
complement binary. As a result, 0 °C corresponds to the numeric value 0x0000
and 100 °C to the numeric value 0x03E8 (dec. 1000).
The possible numeric range corresponds to the defined temperature range of the
sensors from -50 °C to +150 °C.

Table 46: Process image for 750-464/020-000, NTC 10 kOhm setting

Temperature
°C
< -50.0
Underrange
-50.0
0.0
25.0
50.0
100.0
150.0
> 150.0
Overrange
---
Short circuit
1) Temperature values below 0 °C are represented in two's complement binary.
2) When short circuit and wire break monitoring is ON (see section "Behavior in the Event of an
Error")
3) When underrange / overrange limit is ON (see section "Behavior in the Event of an Error")
Resistance
kΩ
Binary
>1144.48
'1110.1100.0111.1000'
3)
1144.48 '1110.1100.0111.1000'
36.35 '0000.0000.0000.0000'
10.00 '0000.0000.1111.1010'
3.36 '0000.0011.0010.0000'
0.59 '0000.0011.1110.1000'
0.155 '0000.0101.1101.1100'
< 0.155
'0000.0101.1101.1100'
3)
< 0.009
'0000.0101.1101.1100'
2)
1)
Numeric value
Hex. Dec.
0xFE0C -500
0xFE0C -500
0x0000
0x00FA 250
0x01F4 500
0x03E8 1000
0x05DC 1500
0x05DC 1500
0x05DC 1500
Process Image 63
Status LED
byte error
hex. AI 1, 2
0x41 on
0x00 off
0 0x00 off
0x00 off
0x00 off
0x00 off
0x51 off
0x42 on
0x52 on
Manual
Version 1.1.0