Step 5: Connecting Ac Output To An Existing Ac Circuit - Xantrex Freedom XC 2000 Owner's Manual

Step 5: Connecting AC Output to an
Existing AC Circuit
ELECTRIC SHOCK AND FIRE HAZARDS
Make sure wiring is disconnected from all electrical sources
n
before handling. All wiring must be done in accordance with
local and national electrical wiring codes.
A manufacturer-tested and approved RCBO (Type B) must
n
be connected to the Freedom XC AC output and RCBO
protection must be provided on every receptacle connected
to the AC hard wired installation, if local regulations require
it.
Failure to follow these instructions can result in death, serious
injury, or equipment damage.
975-0821-01-01
WARNING
NOTICE
EQUIPMENT DAMAGE
Do not connect any AC source (such as a generator or
n
utility power) to the AC output wiring of the Freedom
XC.
The Freedom XC will not operate if its output is connected
n
to AC voltage from another source, and potentially
hazardous or damaging conditions may occur. These
conditions can occur even if the inverter/charger is off.
Failure to follow these instructions can result in equipment
damage.
Do not connect the Freedom XC to an AC branch circuit that has
high-power consumption loads.
The Freedom XC will not operate electric heaters, air conditioners,
stoves, and other electrical appliances that consume more than
its rated output wattage.
Basic Installation Procedures
33