Procedure; Displaying Software Revision, Continued - Tyco 4100ES Operator's Manual

Displaying Software Revision, Continued

Procedure (Cont'd)
Highlight the "Revision Show System Revisions" and press <Select Item> soft key or
4.
<ENTER> to show the System Revisions:
5. Interpret this information as follows:
 SYS REV: Specifies the revision of the executive software (operating firmware of
the FIP) loaded in the panel.
 CFIG FORMAT: Defines the compatibility of the executive and the programmer.
 JOB: Specifies the name of the job loaded in the panel.
 JOB REV: Specifies the revision of the job.
 JOB BUILT: Specifies the date on which the job was built in the programmer.
 MASTER BOOT: Specifies the revision of the master bootloader.
9-4