Viewing and Clearing Historical Logs
Introduction
In this Chapter
When an abnormal condition occurs, a record of the event is placed in one of two logs
generated by the system, depending on the nature of the condition. These logs are:
Historical Alarm Log
Historical Fault Log.
The historical logs contain a time stamp of the events generated by abnormal conditions in the
system. The information displayed with these logs is historical data only and will not contain
any current point status. Separate lists are maintained for alarms and for isolates/faults. This
chapter describes displaying and clearing these historical logs.
Refer to the page number listed in this table for information on a specific topic.
Viewing and Clearing the Historical Alarm and Fault Logs
Chapter 8
Topic
8-1
See Page #
8-2