Table of Contents
Advertisement
Displaying IDNet & Mapnet Device Status, Continued
The point name is called up, using the procedure described in Chapter 4. Currently, the
subpoint 0 is highlighted in the list of points.
Press <Select Item> softkey or <ENTER> for the 0 subpoint to show the basic information
about this point.
Going back to the Direct Point Call-up display, and scrolling the highlight to subpoint 1 (the
photoelectric sensor), and selecting this point will show the detail for subpoint 1 (the detection
element in this example):
Continued on next page
9-12
Advertisement
Table of Contents
