Table of Contents
Advertisement
Basic System Description, Continued
Overview
(continued)
Table 1-1. Components of the Operator Interface (continued)
LED/Key
Warnings - Isolation and Fault indicate when abnormal, non-fire conditions occur.
Isolate LED
and
Isolate Ack Key
Fault LED
and
Fault Ack Key
Alarm Silenced LED
Alarm Silence Key
AC Power LED
System Reset Key
Function/Numeric Keypad - Used to call up points for display and control.
Menu / Next / Previous /
Page Up / Page Dn
Graphic Display
Important Note: The degree to which you are allowed to control the system depends
on the passcode assigned to you. See Chapter 7 for details on this.
Standard Fire Fighter operations do not require a passcode.
Description
When any zone is isolated, this LED
turns on and the buzzer sounds until
Isolate Ack is pressed.
When any fault occurs this LED turns
on and the buzzer sounds until Fault
Ack is pressed.
Not normally used in Australia
Indicates the presence of AC power
at the panel.
Pressing this key directs the panel to
reset all attached devices and clear
all acknowledged alarm and fault
conditions.
Press the Menu key to display the
menu options on the LCD. Next &
Previous allow stepping through
options/events, Page Up and Page
Dn allow larger steps through
options.
Displays text describing abnormal
conditions for devices attached to the
panel (e.g., smoke detector in main
lobby is in alarm). Also displays
system prompts, menus and
messages.
1-4
Refer To
Chapter 3
Chapter 3
N/A
N/A
Chapter 2
Chapter 5 on
Advertisement
Table of Contents
