Switching The Rake From Transport To Working Position - SaMASZ TANGO 730 Operator's Manual

CAUTION:
The telescopic articulated shaft should remain mounted only during the rake's
operation period. For transport and service time the shaft should be
disconnected from the tractor's PTO shaft.
CAUTION:
Use machines with correspondingly designed telescopic articulated drive
shafts. Prior to work commencement, inspect safety guards whether they (in
tractor, machine and shaft) are placed correctly and are not damaged.
Damaged or missing parts must be replaced with genuine ones. Make sure
that the telescopic articulated shaft is mounted properly. Approaching the
rotating parts is strictly forbidden, as it may lead to serious injuries or even
cause death. For any service and repair works of the shaft and the machine,
the tractor engine and spline drive must be disconnected. Prior to the
operation commencement, read the operator's manuals of both the machine
and the shaft.

5.5. Switching the rake from transport to working position

Make sure there is no person around the danger area where the machine is to be lowered.

Unlatch the locking pawls (P) by means of cord (4) (Fig. 10).

By control panel - function (2) (Fig. 8) – and hydraulic lifter, lower rake's arms to working

position.
If raking tines were demounted, remove raking arms from transport holes, mount them in the

rotor and secure with
Lower safety guards.

Instruction manual
Fig. 11. Telescopic articulated shaft shortening instructions
cotters.
- 17 -
Two rotor rake
TANGO