Switching Rake From Forming One To Forming Two Single Rows; Adjustment Of Front Safety Curtain Inclination Angle - SaMASZ TANGO 730 Operator's Manual

5.7.2. Switching rake from forming one to forming two single rows

In order to switch the machine for raking two rows, perform the following:
fold out working assemblies with tractor's hydraulics, so that raking tines on front working

assembly do not overlap with tines on the rear assembly,
open valve on tarpaulin cover mechanism cylinder.

Switching the valve shall cause the cover to get lifted as headlands with working assemblies,
and be set for operation as the machine starts raking.
When forming two rows the rear cover is set the same as when forming a single one.
Once the work is completed, first lift the tarpaulin cover mechanism (Fig. 23) and secure the
valve on cylinder (Fig. 24). Working assemblies can be slid down only when the mechanism is
secured.
CAUTION:
When sliding down the working assemblies, pay particular attention to
tarpaulin cover on the front working assembly – if in lower position its
damage may follow.

5.7.3. Adjustment of front safety curtain inclination angle

Inclination of front safety curtain can be adjusted as needed. The adjustment is done by
unscrewing bolts (S) fixing the safety curtain and screwing them again in the selected holes as
shown in Fig. 27.
S
Instruction manual
Fig. 27. Adjustment of front safety curtain inclination angle
- 23 -
Two rotor rake
TANGO