SaMASZ TANGO 730 Operator's Manual page 21

Before commissioning of the rake, in driving wheels (Fig. 17), replace provisional bolts (S
on joints of steering heads with rear wheel axis for expansion pins Ø16 and Ø10 (K) delivered with
the machine. Install the pins as shown in Fig. 16.
The following should be performed in workplace and as rake is in working position:
connect PTO shaft extension onto tractor's spline shaft (if only one extension was taken out) or

connect the complete PTO shaft,
set the tractor and rake aggregate on an even, level ground,

by means of regulation lever (lift or lower) adjust demanded working height (not lower

than 0.4'' (1 cm) above the ground (Fig. 18).
WARNING!
It is forbidden to lower raking arms below 0.4'' (1 cm) from the ground as
this may cause damages to the machine such as bending the raking arms,
breaking the linkage or the gear, faster wearing of raking tines, damaging the
turf and causing contamination to the collected forage, etc. Too high a raking
set may cause the swath not be collected completely.
Instruction manual
S
1
Fig. 17. Preparing drive system of the rake
Fig. 18. Raking height adjustment lever
- 19 -
Two rotor rake
TANGO
K
)
1