Replacing Fuses; Main Fuses; Maintenance; Service Before Daily Or Short Term Storage - Zetor COMPAX CL Series Operator's Manual

Replacing Fuses

The circuit has 8 blade type fuses in its wiring circuit.
When a fuse has blown replace it with one of the same value.
Using a large capacity fuse or wire burn out the wiring system.
Use fuse tongs to replace fuses.
1 - Normal condition
2 - Blown

Main Fuses

The wiring harness is equipped with three main fuses to protect electrical devices.
However, when the main fuse blows, the whole circuit does not work.
Always check the reason and repair it before replacing the fuse for the fuse of the same value.
To indicated the blown fuse, it will be discolored.
1 - Fuse Box

Maintenance

Service before Daily or Short Term Storage

Wash the tractor and keep it clean.
Fill fuel tank to prevent condensation and corrosion.
Lower all implements to the ground before parking the tractor.
For long-term storage, contact your authorized service center.

For Daily or Short Term Storage

Clean the tractor and remove all dirt.
Refuel the fuel tank to avoid condensation in the tank and corrosion of the fuel system.
Lower the power tool to the ground.
Park the tractor in a dry area with roof, if this is not possible we recommend covering the tractor with a solid
material such as foil or tarpaulin. In very cold conditions, it is advisable to remove the battery and keep it in
a warm environment to ensure functional starting. If the outside temperature is less than 32 °F (0 °C),
replace the coolant completely or drain the coolant circuit to protect the engine from damage with frozen
coolant.
IMPORTANT:
When washing the tractor, make sure that water does not enter the tractor's electrical system

or fuel and lubrication system.
To prevent short circuits remove the ignition key.

Do not wash the tractor when the engine is running.

MAINTENANCE INSTRUCTIONS
89