Oil And Water Separator Cleaning; Changing The Oils In The Tractor; Engine Oil Replacement - Zetor COMPAX CL Series Operator's Manual

Oil and Water Separator Cleaning

If any foreign material or water is visible through the
inspection glass, follow these steps to remove it
1. Prepare a container to collect fuel from the oil/water
separator.
2. Open the drain plug.
3. When sufficient amount of fuel has been drained,
tighten the drain plug by hand.
4. Do not use any tool.
Important: Never use gasoline, thinners or any other flammable materials to clean the fuel
filter.

Changing the Oils in the Tractor

Always use the oil types and classes according to relevant specifications and observe the oil change
intervals. (see Tractor Maintenance chapter).
1 - Engine Oil Dipstick
2 - Engine Oil Filter
3 - Engine Oil Filler

Engine Oil Replacement

Park the tractor on a level surface, turn off the engine and remove the drain plug and drain the oil.
Reinstall and check the drain plug and fill the engine with oil to the correct level on the dipstick
(approximately 2.7 l (0.71 US gal)).
The grade of oil to be used will depend on the ambient temperature. See the temperature table.
The tractor is shipped from the factory with 10W-30 oil.
Important:
Always replace the oil filter when changing the oil.

Always use the same oil, as using different types of oils or oils with different specifications

can cause damage. The drained oil must be disposed of in accordance with local regulations.
78
MAINTENANCE INSTRUCTIONS