Long-Term Storage; Re-Use After Long Term Storage - Zetor COMPAX CL Series Operator's Manual

Long-term Storage

When the tractor will not be used for a long time perform the cleaning as for short term storage.
Drain and replace the oil. Start the engine for approx. 5 minutes to refill the engine with new oil.
Drain the coolant from the radiator and remove the ignition key.
Attach the 'NO COOLANT' sign to both the key and the steering wheel.
Lubricate all lubrication points on the tractor.
Check the tire pressures if necessary to overinflate slightly due to the machine being stationary for a long
time.
Lower all attached implements on the ground or disconnect the unit if necessary.
Disconnect the clutch using the clutch release arm.
Place a wooden support under each tire to preserve its characteristics.
Refuel the fuel tank to avoid condensation in the tank and corrosion of the fuel system.
Important:
After refilling the engine with the coolant run the engine for approx. 5~10 min. at 1,500~2,000

rpm every month as a corrosion prevention measure.
Either removes the battery or the negative terminal as mouse damage to wiring can cause

short circuits and fires.
Remove the ignition key and store in a safe place.


Re-use After Long Term Storage

Carry out a full check of all oils and coolant.
Refit the battery and run the engine at idle for 30 min. to ensure optimum engine life.
90
MAINTENANCE INSTRUCTIONS