Table of Contents
Advertisement
VarioGuide
Aligning the VarioGuide to the Planned Trajectory and Verifying Accuracy
Before You Begin
So that the software can detect the
VarioGuide
Once the software recognizes the instrument, the first alignment dialog opens.
About the
Three adjustment joints (
Adjustment Steps
VarioGuide
• Loosen the joint indicated in each dialog. The software recognizes the corresponding
• When the deviation is close to 0°, the software displays
• The software prompts you to the next adjustment step. You can also move to subse-
NOTE: The software allows you to proceed to the next step even if the light is not shown
green. Make sure that the accuracy is sufficient before proceeding.
Realigning the
VarioGuide
184
by 60°.
Joint 1
. To perform each adjustment:
joint and displays the value by which to adjust the joint.
the light is shown in green
quent steps by pressing
Proceed
If you modify the guide disk, or if you change the instrument diameter, you
must realign the
VarioGuide
VarioGuide
position, rotate the disk joint on the
,
Joint 2
and
Joint 3
) must be adjusted to align the
.
to the trajectory.
Software User Guide Rev. 1.0 Kolibri cranial/ENT Ver. 2.7
Lock joint!
in the dialog and
Advertisement
Table of Contents
