The Usb Power Supply; Power On Or Off - GE Druck DPI 620 User Manual

Issue 1
1
3
2.7 The USB power
supply
1
2
4

2.8 Power on or off

2-4 Prepare the instrument
If there is a battery, internal safety circuits control the charge
cycle. If you are using the instrument, this increases the time to
charge the battery.
Step Procedure
1.
Attach the applicable socket adaptor to the DC
power supply.
2. On the right-hand side of the instrument
2
(Figure
the cover for the connections.
3. Push the power supply connector into the 5 V DC
input socket and set the power on.
You can use the optional mini Type B cable to supply power to
the instrument.
This charges the battery when the instrument is off and
increases the battery life when the instrument is on.
Step Procedure
1.
Start the computer.
3
2. Push the Type A end of the USB cable into a USB
socket on your computer.
3. On the right-hand side of the instrument
(Figure
the cover for the connections.
4.
Push the mini Type B end of the USB cable into
the USB socket on the instrument.
To set the instrument power on, press and hold this button
down until the display comes on (| 2 seconds). During the
power on sequence, the instrument shows a timer and then
shows the applicable data.
To set the instrument power off, press and release this button
again. When the power is off, the last set of configuration
options stays in memory.
1-3), use the rubber recess to pull down
1-3), use the rubber recess to pull down
K0449 - [EN] English