Available Hart Commands - GE Druck DPI 620 User Manual

Issue 1
8.3 Available HART
commands
Command name
Return device ID, hardware/firmware version,
HART ID, Number of preambles,
manufacturer/model
Primary Variable (PV) and units
Read loop current
Tagged poll version of #0 (Command 0)
Read Tag descriptor and date
Read primary variable transducer serial number,
upper lower transducer limits, minimum span
Primary damping value, write protect mode,
alarm
Write Tag descriptor and date
Write primary damping factor
Write primary variable range values – LRV &
URV
Set primary URV "Span"
Set primary LRV "Zero"
Reset configuration changed counter
Enter/Exit fixed current mode - loopback test
Perform self test
Perform device reset
Set primary variable zero "Tare"
Write primary variable units
Trim loop current zero
Trim loop current gain
®
8-2 HART device operations
This is a list of the commands that are available with the
DPI 620 calibrator:
Note: HART revision 5 field devices do not support some of
these commands.
Command
number
Menu
#0 Hart hardware info
#1 PV display screen
#2 PV display screen
#11 Tagged poll mode
#13 Hart hardware info
#14 Hart Sensor Info
#15 Hart Sensor Info
#18 Hart hardware info
#34 Hart Sensor Info
#35 Re-range menu
#36 Re-range menu
#37 Re-range menu
#38 Calibrate menu
#40 Trim Menu
#41 Calibrate menu
#42 Calibrate menu
#43 Re-range menu
#44 Advanced device
menu
#45 Trim Menu
#46 Trim Menu
Type and
revision level
Universal - 5
Universal - 5
Universal - 5
Universal - 5
Universal - 5
Universal - 5
Universal - 5
Universal - 5
Common - 5
Common - 5
Common - 5
Common - 5
Common - 5
Universal - 5
Common - 5
Common - 5
Common - 5
Common - 5
Common - 5
Common - 5
K0449 - [EN] English