3.3.1 Assembly instructions
3
3.3.2 IDOS function
procedures
2
3
1
TAP
A
3
B
C
[EN] English - K0449
Step
Procedure
1.
Attach one end of the adaptor (IO620-IDOS-USB) to the
applicable IDOS module.
1
2.
On the right-hand side of the instrument
use the rubber recess to pull down the cover for the
2
connections.
3.
Push the Type A end of the adaptor (IO620-IDOS-USB)
into the USB socket on the instrument.
4.
When this symbol flashes at the top of the display, it
shows there is communication between the IDOS
module and the calibrator.
When the assembly is complete
these procedures to measure the pressure with the IDOS
function:
•
Set the calibrator functions you want to use on the display;
see
Section
2.10.3. This includes:
a. IDOS function (to measure the pressure): item
b. other functions (maximum: 6 functions); see
•
If necessary, change the Units for the function: item
see
Section 2.10.5
•
If necessary, set a Utility for the function: item
Section 2.10.6
a. Max/Min/Avg
b. Switch Test
Set the instrument power on.
(Section
Electrical and IDOS operations 3-11
Issue 1
(Figure
1-3),
3.3.1), you can use
;
A
Section 3.2
B
;
C
; see