Status Signals - Otto Bock Kenevo 3C60 Instructions For Use Manual

Appendices
Beep signal
30 x long
Error while charging the product
LED on LED on Battery charger
power battery connected to
supply charger product
No
Yes
Beep signal
4 x short at intervals of
approx. 20 sec. (continu­
ously)

14.2.3 Status signals

Battery charger connected
LED on LED on
power sup­ battery
ply charger
38
Vibration signal
1 x long, 1 x short
repeated every 3 seconds
Error
Country-specific plug adapter not
fully engaged on power supply
Non-functional socket
Defective power supply
Distance between battery charger
and receiver of the charging unit
too big
No connection between battery
charger and power supply
Defective battery charger
Error
Charging the battery outside the allowable
temperature range
Event
When connecting the power supply to the outlet, the LED on the battery charger lights
up briefly
Power supply and battery charger operational
Event
Severe error/indication
of safety mode activa­
tion
For example, a sensor is
not operational, AXON
tube adapter not connec­
ted or valve drive failure
Possibly no switching into
safety mode.
Resolution
Check whether the country-specific
plug adapter is fully engaged on
the power supply.
Check socket with another electric
appliance.
The battery charger and power
supply must be inspected by an
authorised
Centre.
The distance between the battery
charger and the receiver on the
product must not exceed 1 mm /
0.04 inch
Check whether the charging cable
plug is fully engaged on the battery
charger.
The battery charger and power
supply must be inspected by an
authorised
Centre.
Resolution
Check whether the specified ambient con­
ditions for charging the battery are met
(see Page 34).
Required action
Walking possible with restric­
tions. Please note the possible
change in flexion/extension
resistance.
Attempt to reset this error by
connecting/disconnecting the
battery charger. The battery
charger must remain connec­
ted for at least 5 seconds
before it is disconnected.
If the error persists, use of the
product is prohibited. The
product must be inspected by
an authorised Ottobock Ser­
vice Centre.
Ottobock
Ottobock
Kenevo 3C60/3C60=ST
Service
Service