Operating States/Error Signals; Signals For Operating States; Warnings/Error Signals - Otto Bock Kenevo 3C60 Instructions For Use Manual

Protect from moisture
Protection against penetration of solid foreign objects with a diameter greater than 12.5 mm, no
protection against water
Protection against penetration of solid foreign objects with a diameter greater than 12.5 mm, pro­
tection against water dripping diagonally up to 15°.
Caution, hot surface

14.2 Operating states/error signals

The prosthesis indicates operating states and error messages through beeps and vibration signals.

14.2.1 Signals for operating states

Battery charger connected/disconnected
Beep signal
1 x short
1 x short

14.2.2 Warnings/error signals

Error during use
Beep signal
10 x long
Kenevo 3C60/3C60=ST
Vibration signal
None
3 x short
1x before beep signal
Vibration signal
1 x long at interval of
approx. 5 seconds
3 x long
5 x long
10 x long
Event
Battery charger connected or
battery charger already disconnected prior to start of char­
ging mode
Charging mode started (3 sec. after connecting the bat­
tery charger)
Battery charger disconnected after start of charging mode
Event
Overheated hydraulic unit Reduce activity.
Battery charge level
under 35%
Battery charge level
under 20%
Battery charge level
under 15%
After the beep and vibra­
tion signals, the product
switches to empty battery
mode and then switches
off.
Appendices
Required action
Charge battery soon.
Charge battery immediately;
the product will be switched
off after the next warning sig­
nal.
Charge the battery.
37