Preparing For Installation; Safety Recommendations; Safety Symbols; General Safety Recommendations - H3C SecPath F10 0 Series Installation Manual

Preparing for installation

The H3C SecPath F10X0 firewall series include the following models:
•
F1005
•
F1010
•
F1020
•
F1030
•
F1050
•
F1060
•
F1070
•
F1080
•
F1090
NOTE:
The term "hard disk" in this document refers to a drive.

Safety recommendations

To avoid any equipment damage or bodily injury, read the following safety recommendations before
installation. Note that the recommendations do not cover every possible hazardous condition.

Safety symbols

When reading this document, note the following symbols:
WARNING means an alert that calls attention to important information that if not understood or
followed can result in personal injury.
CAUTION means an alert that calls attention to important information that if not understood or
followed can result in data loss, data corruption, or damage to hardware or software.

General safety recommendations

•
Do not place the firewall on an unstable case or desk. The firewall might be severely damaged
in case of a fall.
•
Make sure the ground is dry and flat and anti-slip measures are in place.
•
Keep the chassis and installation tools away from walk areas.
•
Keep the chassis clean and dust-free.
•
Do not place the firewall near water or in a damp environment. Prevent water or moisture from
entering the firewall chassis.
•
Ensure good ventilation of the equipment room and keep the air inlet and outlet vents of the
firewall free of obstruction.
•
Make sure the operating voltage is in the required range.
•
Use a screwdriver, rather than your fingers, to fasten screws.
•
Stack devices according to the sizes of and packing symbols on the packages.
1