H3C SecPath F10 0 Series Installation Manual page 29

Connecting an AC power cord for an F1020, F1030, F1050, or F1060 firewall
Connect the connector of the AC power cord to the target AC power receptacle on the rear
1.
panel of the chassis. Then use a power cord retainer clip (see
(see Figure
Connect the other end of the power cord to an AC power source.
2.
Figure 25 Connecting an AC power cord (using a power cord retainer clip to secure the
power cord)
Figure 26 Connecting an AC power cord (using a cable tie to secure the power cord)
1
Connecting an AC power cord for an F1070 or F1080 firewall
Connect the connector of the AC power cord to the AC power receptacle on the rear panel of
1.
the chassis. Then use a power cord retainer clip (see
secure the power cord.
Connect the other end of the power cord to an AC power source.
2.
Figure 27 Connecting an AC power cord (using a power cord retainer clip to secure the
power cord)
26) to secure the power cord.
Figure 27) or a cable tie (see
22
Figure 25) or a cable tie
2
Figure 28) to