Instruments With Removable Drives - Keysight X Series Security Features And Document Of Volatility

Disk Drive Removal Procedure

Instruments with Removable Drives

Instruments with Removable Drives
To remove the disk drive, follow the procedure below. You do not need to
remove the Processor Assembly from the instrument before removing the drive.
The numbered items in the figures below correspond to the step numbers in
the procedure.
CAUTION
Before removing the disk drive, ensure that the instrument's power is turned
off.
1. Locate the Processor and Disk Drive Assembly on the instrument's rear panel, as
Figure 7-2 Processor Assembly with Removable Disk Drive
2. Locate the removable drive, and its retaining thumbscrew, as shown in
3. Turn the thumbscrew to release the drive from the panel, as shown in
Security Features & Document of Volatility
shown in Figure 2-2 in the section
7-2 below, the processor assembly is shown removed from the rear panel for clarity.
below. If the thumbscrew is too tight to turn by hand, use a TORX T10 screwdriver to
loosen it.
"Rear Panel Configurations" on page 12. In Figure
Figure 7-2.
Figure 7-3
55