Cisco Webex Room Panorama Installation Manual page 82

32
Finish up
32.1 Cleaning
Both the screens and the steel structure are
sensitive to fingerprints and probably requires
some cleaning.
Cleaning the screens:
• Be sure that the screen is not connected to
power.
• Use a soft and dry cloth such as superfine
fibers or cotton flannels. The surface of the
product and the display are vulnerable to
scratches.
• Do not apply chemicals containing alcohol,
solvent, or surfactant such as wax, benzene,
thinner, pesticide, air freshener, lubricant, or
cleaner to the product.
Steel and aluminum parts:
• Apply a small amount of non-alcohol-based
cleaning agents onto a soft, clean, lint-free
cloth, and gently wipe the surface.
Cosmetic wall:
• Cleanings is done by dry mop or vacuum. Use
synthetic cleaning fluid without ammonia for
greasy stains, fruit, wine and coffee. Blood is
removed with cold water.
• The UV coated and laminate surfaces are
approved for hospital cleaning products
containing up to 70% alcohol.
You can read our general guidelines on how to
clean or disinfect Cisco Webex Rooms here:
https://help.webex.com/n6biz7y/
80
32 2 Connect to power
1. Use the handles to pull down the main
screens.
2. Connect all the power cables to the socket
outlets in the left and right power cavities.
3. Connect the Ethernet switch under the table to
power.
4. The following components has a power switch.
They should be On:
• Codec
• Camera
• 24 V PSU (the largest PSU in the left power
cavity)
5. The screens should automatically power up.
If they don't, use the remote control or power
button to switch them on.
• Main screens: power button below the
logo (lower right)
• Content screen: power button (lower
center)
6. Use the handles to push the main screens
back in place.
Allow the system to initialize. Some components
may have to reboot. This may take several
minutes.
32.3 What's next
Follow the instructions in the Getting Started
Guide to finalize the installation. These steps are
mandatory:
1. Register the system
2. Follow the Setup assistant (on the Touch
controller)
3. Calibrate all screens
Download the Getting Started Guide from here:
https://www.cisco.com/go/panorama-installation