Cisco Webex Room Panorama Installation Manual page 54

20.9 Mount the upper front panels
Repeat the procedure on both sides.
1. Slide the upper front panel on to the profiles,
both at the bottom and at the outer side.
Make sure to fit the groove of the panel fully
onto both profiles.
Profiles
52
2. Make the split line between the upper front panel and the corner panel as tight and even as possible.
If the split line is uneven:
• Take the front panel off.
• Loosen the screws of the horizontal profile on which the panel rests, and adjust its position.
• Tighten the screws, and put the front panel back on.
Repeat these steps until the split line is tight and even
If the gap is larger at the top, lower the
end of the profile that is closest to the
corner, and lift the other end.
POWER POWER
RS232C RS232C DIGITAL DIGITAL LAN LAN HDMI IN HDMI IN ONE CONNECT ONE CONNECT
IN IN AUDIO OUT AUDIO OUT
HDMI 1 HDMI 1 HDMI 2 HDMI 2 HDMI 3 HDMI 3 HDMI 4 HDMI 4
(OPTICAL) (OPTICAL) (ARC) (ARC)
If the gap is larger at the bottom, lift the
end of the profile that is closest to the
corner, and lower the other end.
POWER POWER
RS232C RS232C DIGITAL DIGITAL LAN LAN HDMI IN HDMI IN ONE CONNECT ONE CONNECT
IN IN AUDIO OUT AUDIO OUT
HDMI 1 HDMI 1 HDMI 2 HDMI 2 HDMI 3 HDMI 3 HDMI 4 HDMI 4
(OPTICAL) (OPTICAL) (ARC) (ARC)