Cisco Webex Room Panorama Installation Manual page 42

18
Mount the upper trim
The top trim and its support are fastened to
the risers and rails as shown in the close-up
illustrations.
Repeat the procedure for both the left and right
trims.
Upper trim
2x
Upper trim support, left and right
2x
Upper trim, left and right
6x 4x
(M6x12, Torx 30) (Nylon spacer, 5 mm)
12x 8x
(M4x12, Torx 20) (Washer, 0.9 mm)
40
18.1 Fasten the upper trim support
1. Enter three screws
and risers as shown, without tightening.
E4
E4
into the rail
(M6x12, Torx 30)
Don't tighten the
screws so much that
it becomes difficult
to hang the trim
support on them.
2. Hang the trim support onto the screws. You
may need to use some force to get the trim
support onto the corner screw.
3. Tighten the three screws.