Mount The Switch - Cisco Webex Room Panorama Installation Manual

30
Mount the Ethernet switch in the table
This Ethernet switch is used for the Cisco Touch
panels (user interfaces). You may have one or two
of those.
We recommend mounting the switch under the
table, or somewhere close to the table.
This switch is connected to the internal Room
Panorama network, and cannot be used to access
the company LAN or Internet.
Ethernet switch
1x
Ethernet switch C4
1x
Mounting tray A6
2x
(PAN10-32x0.3 1 2, PH2)
78

30.1 Mount the switch.

Find information how to mount the switch and
mounting tray on pages 26-28 in the Catalyst
3560-CX and 2960-CX Switch Hardware
Installation Guide:
https://www.cisco.com/c/en/us/td/docs/
switches/lan/catalyst2960cx_3650cx/
hardware/installation/guide/b_2960cx-
3560cx_hig.pdf
To prevent airflow restriction, allow clearance
around the ventilation openings to be at least 8 cm
(3 in.).
30.2 Connect the switch to the codec
Connect the Ethernet switch to the codec as
shown in the wiring diagram:
• 1x Ethernet (X1)
This is the Ethernet cable that you pulled through
the flex tubes and connected to the codec in step
29.
Don't connect the switch to power yet.