Cisco Webex Room Panorama Installation Manual page 52

20.7 Mount the upper corner panels
Repeat the procedure on both sides.
1. Place the upper corner panel on top of the
lower corner panel.
Make sure to fit the groove of the panel fully
into the profiles on the joining module on all
sides. Also check that the slots at the rear side
of the panel enter the corresponding screws
with spacers.
2. Give the panel a firm push at the top, so that
the slots at the rear side of the panel enter the
corresponding screws with spacers on the
upper trim.
50
3. Make the split line between the upper and
lower corner panels as tight and even as
possible.
If the gap is larger at the front, push the
panels backward until the gap is even.
If the gap is larger at the back, pull the
panels forward until the gap is even.
When done, tighten the screws from steps
20.1 and 20.2 to secure the position of the
panels.
Access these screws behind
the corner panel