Cisco Webex Room Panorama Installation Manual page 48

20.2 Mount a joining module on top of the lower corner panel
Repeat the procedure on both sides.
1. Fasten the vertical profile (
3203 #1
screws .
(M4x12, Torx 20)
2. Add two screws with spacers
.
Nylon spacer, 5 mm)
Add spacers to
these screws.
46
) with two 3. Fasten the two horizontal profiles (
two screws
Note that two screws have spacers
(Nylon spacer, 5 mm)
(M4x12, Torx 20;
) with
3201 #3
each.
(M4x12, Torx 20)
.
Add spacers to
these screws.
4. Place the joining module onto the corner
panel.
Make sure to fit the module fully into the
groove of the panel on all sides. Check
that the screws with spacers enter the
corresponding slots at the rear side of the
panel.
5. Fasten the module with two screws
.
(M4x12, Torx 20)
Only tighten the one at front.
this screw now.
Do not tighten