ADC Soneplex Broadband System Operation And Maintenance Manual page 327

ADCP-61-471 • Issue 4 • June 2000 • Section 2: Operation and Maintenance
TAP-102
Page 5 of 11
MON TYPE MEANING
FCP Failure Count Path
CVP Code Violation Path
ESP Errored Second Path
SESP Severely Errored
Second Path
SEFSP Severely Errored
Framing Second Path
PA-H Pulse Attenuation
High Path
SNR-L Signal-to-Noise Ratio
Low Path
–
* For descriptions of locations where thresholds are monitored (such as FEND, NEND, REPC, REPR,
CRP, and RRP), refer to Figure 102-7
system), Figure 102-10 (ODS2 system), and
2-304
© 2000, ADC Telecommunications, Inc.
Table 102-2. HDSL Mon Type Descriptions
LOCATION
NEND, FEND, REPC,
REPR, CRP, RRP*
NEND, FEND, REPC,
REPR, CRP, RRP
NEND, FEND, REPC,
REPR, CRP, RRP
NEND, FEND, REPC,
REPR, CRP, RRP
NEND, FEND, REPC,
REPR, CRP, RRP
NEND, FEND, REPC,
–
REPR, CRP, RRP
NEND, FEND, REPC,
REPR, CRP, RRP
(T1 system), Figure 102-8
Figure 102-11
DESCRIPTION
Count of Loss Of Sync Word (LOSW)
failures on the HDSL loop.
Count of CRC errors on the HDSL loop.
A second in which one or more CRC
errors occurred on the HDSL loop, and
no LOSW defects occurred.
A second in which the number of CRC
errors on the HDSL loop was greater
than or equal to some user-specified
value, and no LOSW defects occurred.
A second in which one or more LOSW
defects occurred on the HDSL loop.
Highest Pulse Attenuation value detected
on the HDSL loop within the interval.
This value is only updated when the
HDSL loop is active. If the HDSL loop
has never been activated, this value will
be set to 0.
Lowest SNR detected on the HDSL loop
within the interval. This value is only
updated when the HDSL loop is active.
If the HDSL loop has never been
activated, this value will be set to 71.
(HDSL system), Figure 102-9
(RLX system).
(DLX