ADC Soneplex Broadband System Operation And Maintenance Manual page 131

ADCP-61-471 • Issue 4 • June 2000 • Section 2: Operation and Maintenance
DLP-532
Page 3 of 3
FIELD TYPE
T1 Provision Toggle
T1 Service State Toggle
T1 Line Code Toggle
Pulse Equalization Toggle
T1 BER Toggle
Threshold
Loopback Input
Timeout Period
Circuit Identifier Input
T1 Service State Toggle
2-108
© 2000, ADC Telecommunications, Inc.
Table 533-1. DLX Configuration Fields, continued
OPTIONS
YES
NO
Leave this field at OOS at this time to avoid undesirable reporting of alarms. Place the circuit In-
Service after complete the remaining configurations.
AMI
B8ZS
0–133 ft., 133–266 ft.,
266–399 ft., 399–533 ft., or
533–655 ft.
T1 BER Threshold can be set between
10 -3 and 10 -9 .
Enter a number from 0 to 255.
Up to 20 characters.
IS (In-Service)
OOS (Out-Of-Service)
DESCRIPTION
Brings up T1 default settings and
allows configuration changes.
Prevents configuration settings.
Alternate Mark Inversion
Bipolar Eight-Zero Substitution
The DS1 signal output provides
standard DSX signal levels which
can be compensated for various
distances.
When the Bit Error Rate threshold
is exceeded, an alarm is triggered.
This field represents the number of
minutes that the loopback remains
in effect before reverting to the
normal (non-loopback) state.
Setting the loopback time-out
period to 0 disables the time-out
feature.
This represents the customer's
circuit ID. The first and last
characters must be alpha or
numeric; middle characters can be
alpha, numeric or hyphens.
Allows T1 alarms to be reported to
the MPU.
Prevents T1 alarms from being
reported to the MPU.
DEFAULT
NO
AMI
0–133 ft.
10 -7
30
None
OOS