Figure 3-16. Connecting A Workstation To An Attachment Port (Baystack 28104/Adv) - Bay Networks BayStack 281 Series Manual

Installing the BayStack 281xx Switch
Connecting Individual Workstations, Servers, or Ethernet Devices
3-16
The type of cable you use to connect workstations or other Ethernet devices to
the BayStack 281xx switch is determined by the model of the BayStack 281xx
switch and the segment distance between the Ethernet device and the
BayStack 281xx switch. See Table 2-1 in Chapter 2, "Planning a Switched
Network," for port cable options.
To connect an individual workstation, server, or Ethernet device to the
BayStack 281xx switch, follow these steps:
1. Insert the connector into the desired attachment port, as shown in
Figure 3-16.
Service Port
Figure 3-16. Connecting a workstation to an attachment port
(BayStack 28104/ADV)
The link LEDs do not light until the other end of the cable is connected to
a network device. Additional LEDs may be illuminated because of other
configuration conditions.
2. Connect the other end of the cable to the desired network device.
Partition
1
2
Link HSp Link HSp
Part Col Part Col
1 2
5988
893-00965-A